Photoshop pull out the wedding photo shades of Maya

Original

Final effect Diagram

The first step: Open the original image, copy the layer.

Step Two: Adjust layer, click Layer-New adjustment layer-channel mixer, select Gray, add mask, brush red petals with brushes, parameters are set as follows:

Step three: Click on the Layer-the new adjustment layer-curve, using the curve or color to call out the tone (one can use), the parameters are set as follows:

Fourth Step: Click the Layer-new adjustment layer-hue/saturation, select the green channel, the parameters are set as follows:

Fifth step: The basic color of the film has been out, a new layer stamped (shift+ctrl+alt+e) effect of the following figure:

Sixth step: Copy Layer 1, get a copy of the layer of the copy to reduce noise, add masks to wipe out the characters, and then stamped (shift+ctrl+alt+e), click on the filter-blur-Gaussian blur, parameters as set out below:

Seventh Step: Add a mask, with the gradient pull out to blur the place, wipe out the character theme, because before using the noise, the character edge should be more clear, the final adjustment of color levels, complete.

Note : More wonderful tutorials Please pay attention to the triple Photoshop tutorial section, triple PS group: 182958314 welcome you to join

Category:

• PS Image Processing