Photoshop Recovery-scanned old photos for two-inch electronic photos
There are some folds in the old picture, and the edges are white and the photos are not very good. I'll show you how to deal with these problems, including straightening photos, removing photos, white edges, setting photos, standard size, and getting the folds and blemishes back to normal.
Method/Step
1, open Photoshop to drag the scanned old photos to the Photoshop interface
2. Use the ruler tool to pull a straight line along the blue edge of the photo and click the Straighten Layer tool
3, in the Toolbox in the cutting tool or press the shortcut key C drag out the trim box and then drag the cutting box to cut off the white edge
4, drag the image label so that the image interface suspended in the Photoshop interface in the image label click on the right button to set the width of the image size to 3.5cm height set to 5.3cm
5, straighten the correction to the white side set the size of the picture after observing some of the wrinkles produced by the following image of the red Box red circle shown
6, click the contents of the toolbar to feel the mobile tool and then drag out a piece of the interior with a defective area click on the menu bar edit in the pop-up dialog box to identify the contents and click OK
7, the above method is applicable to a selection of multiple defective areas and then click Edit Content to identify and then determine
8, this is the effect of complete treatment of defects
9, this is the old photos before and after the treatment of the control
The above is the use of Photoshop Restore scan old photos for two-inch electronic photo graphics and text tutorial, I hope to help you!
Classification: