Photoshop to create a classic green scene wedding film tutorial

The color composition of the picture is relatively simple, mainly green and red. Color palette is also simpler, you can directly use the palette to pull out the color you want. You can also use channels to color. After the main color is good, the local plus the halo, enhances the picture the high light.

Original

< small map view big picture >

Final effect

< small map view big picture >

1, open the original material, the background layer to copy a layer. Enter the channel panel, select the green channel, press CTRL + A all, and press CTRL + C to copy. Select the Blue channel CTRL + V paste, point RGB channel, back to the layers panel, the effect of the following figure.

< map 1>

2, create an optional color adjustment layer, red, green, white, black to adjust, parameter settings such as Figure 2-5, the effect is shown in Figure 6. This step turns the red in the picture to orange-red and cyan to green.

< map 2>

< map 3>

< map 4>

< map 5>

< map 6>

3, create an optional color adjustment layer, yellow, white, black to adjust, parameter settings such as Figure 7-9, the effect is shown in Figure 10. This step adds dark blue to the dark part of the picture.

< map 7>

< map 8>

< map 9>

< map 10>

4, create curve adjustment layer, the blue adjustment, parameter settings such as Figure 11, the effect is shown in Figure 12. This step increases the picture blue.

< map 11>

< map 12>

5, create color balance adjustment layer, shadow, highlight adjustment, parameter settings such as Figure 13,14, after the layer opacity to: 60%, the effect of Figure 15. This step is to fine-tune the color of the dark and high light.

< map 13>

< map 14>

< map 15>

6, create an optional color adjustment layer, red, yellow, white to adjust, parameter settings such as Figure 16-18, the effect is shown in Figure 19. This step is to fine-tune the picture's orange-red.

< map 16>

< map 17>

< map 18>

< map 19>

7, press CTRL + J to copy the current optional color adjustment layer, the opacity to: 60%, the effect of the following figure.

< map 20>

8, create brightness/Contrast adjustment layer, appropriate to increase the contrast of the picture, parameter settings such as Figure 21, the effect is shown in Figure 22.

< map 21>

< map 22>

9, create a new layer, with the elliptical marquee tool, pull out the oval selection shown in the figure below, press CTRL + ALT + D Feather 60 pixels After the fill pink: #FA965F, blending mode to "filter", the effect of the following figure.

< map 23>

10, cancel the selection, press CTRL + J to copy the current fill layer, blending mode to "soft light", the effect of the following figure. If you feel that the concentration is not enough, you can duplicate the layer.

< map 24>

11. Create a new layer and fill it with black. Execute: Filter > Render > Lens flare, set your favorite halo according to your preferences. After the determination of the layer blending mode to "filter Color", and then put the halo in the appropriate position, the effect of the following figure.

< map 25>

12, create a new layer, press CTRL + ALT + Shift + E-stamped layer. Blending mode to "multiply", opacity to: 40%, plus layer mask, with a black brush to wipe out the middle part, the effect of the following figure.

< map 26>

Finally fine-tune the details and the overall color to complete the final effect.

< small map view big picture >

Category:

• PS Palette Tutorial