To the users of Photoshop software to say the color of the weak light photo method.
First of all, this set of pictures of the environment, this set of pictures in their own bedroom, the time is more than five o'clock in the afternoon, so the sky is basically in the state of Black is no light. And I personally prefer the feeling of natural light, so there is no use of flash, in fact halfway have tried to take a few shots with a flash, the effect does not have this yellow feeling, so simply did not use the flash.
This situation must use all ambient light to let the model's face light up, so the entire filming process is to let the model face as close to the light string, using light string light to highlight the face, and then later to further highlight.
First of all, look at the original film and finished comparison chart:
Original (left) film (right)
I know that just looking at this picture a lot of people will say, this is not the whole point of light? It turns out it's not that simple, and then you see what the overall effect is.
1. Use Photoshop to open RAW format original, the photo will automatically be loaded into camera raw. (here to specify the next weak light photography without raw format is simply dead, with a JPG to shoot the bottom of the basically do not have to look, because it has been powerless.) And then the basic plate to adjust the light effect, to put it plainly, please mention the bright light, the specific parameters to see the figure, but the parameters of each picture is not the same, we only use to remember which places need to be lit on the line, the specific light how much according to each picture of the naked eye observation.
This side of the whole body to lighten up while reducing the brightness of a little highlights, because if you do not lower the highlight area will be exposed, the lower point will be much softer.
After the light is raised
2. The overall light after the discovery of the face is not bright enough, the picture must have a visual center, and portrait of the visual center is generally face, so the face must be lit up, can not be a string of lights to steal the limelight. We use a local adjustment brush to lighten the face.
In the above toolbar to select the local adjustment brush, on the right side will brush the exposure of a little bit, and then go to brush red circle out of the face and surrounding area, you can lift, if you do not feel bright enough to repeat the smear, directly to the right exposure value continues to increase.
3. Next is the Curve palette, will be red, green, blue channel are pulled into S-type, will produce bright yellow, dark part of the effect of green. RGB Channel curve raised to let the dark part of a little light, high light pressure a little bit to make the picture softer, get the following hue.
Here to do not know the curve color principle of the students do a popular science. The curve is divided into four channels, the RGB channel control is the brightness, red-blue-green channel control is the color, in the RGB channel will move the curve up will be brighter, and the lower move will darken. The other three color channels are also the same, red channel curve up to red, down to green, because red and cyan is complementary color (contrast color).
Two colors with 180 degrees of angle on the color ring are complementary colors
4. After adjusting the curve, click on "Open Image" will be adjusted after the picture in Photoshop grinding skin, the person's skin treatment can be clean out of the film, rub the skin here is not explained in detail.
Well, the above information is small compiled for you photoshop This software users brought the detailed weak light photo of the color method to share the whole content, in general this time to teach you to use local adjustment brush and curve tools minutes of waste processing into large tracts, hope to help.
