Procedure and command for configuring H3C telnet

This article describes how to configure telnet for H3C and the specific steps and commands. The following article will give you a detailed introduction, I believe this article will help you.

1. Configure the IP address for H3C telnet login

2. Go to the user interface View

3. Set the authentication method to password authentication.

4. Set the password for login verification to the plaintext password "huawei"

5. Set the login user level to the highest level 3 (level 1 by default)

Password-only Logon:

1. Configure the IP address for H3C telnet login

<SwitchA> system-view

[SwitchA] vlan 1

A [SwitchA-vlan1] port Ethernet 1/0/1

[SwitchA-vlan1] quit

[SwitchA] management-vlan 1 (management VLAN, default VLAN 1). Use this command only if you need to modify it)

[SwitchA] interface vlan 1

[SwitchA-Vlan-interface1] ip address 192.168.0.1 24

2. Go to the user interface view for configuring H3C telnet

[SwitchA] user-interface vty 0 4

3. Set the authentication method to password authentication.

[SwitchA-ui-vty0-4] authentication-mode password ([scheme], mode used to verify the user name and password)

4. Set the password for login verification to the plaintext password "huawei" (this is not required if scheme mode is used)

[SwitchA-ui-vty0-4] set authentication password simple huawei

5. Set the login user level to the highest level 3 (level 1 by default)

[SwitchA-ui-vty0-4] user privilege level 3

For example, if the scheme mode is selected for Article 1, add the following command:

6. Add a user for telnet management. The user type is "telnet", the user name is "huawei", and the password is "admin"

[SwitchA] local-user huawei

[SwitchA-luser-huawei] service-typetelnetlevel 3

[SwitchA-luser-huawei] password simple admin

Complete the H3C telnet configuration process.