Proof that the H3C simulator Wvrp5.2a does not support sub-interface experiments

A brief description of the experiment that the H3C simulator Wvrp5.2a does not support sub-interfaces: There is no configuration information in it. I have pasted the configuration information behind the article, if you are interested, you can stick it to the corresponding device to achieve the experiment effect.
1. The first figure is your topology. This is my own figure. The vswitches are connected to the three routers respectively. I have noted the address plan on the figure; www.2cto.com
2. In the second figure, there is a problem with the topology generated by the Xiaohui simulator. After the topology is generated, the switch cannot be started automatically. You need to find switch. bat in the corresponding folder to start it;

3. The interface status on the third figure router RT1, and the result of ping RT2 RT3;

4. The interface status on the vro2 RT2 in the fourth figure, and the result of ping RT1 RT3; because of the limited image size (RT2 and RT3 won't be passed) 5. The fifth figure shows the interface status on the router RT3, and the result of ping RT1 RT2; 6. The sixth figure shows the interface status on the router SW; ############ RT1 configuration ################ sys www.2cto.com sysname RT1int Eth0/0/0ip add 1.1.1.1 24ip route-static 2.2.2.0 255.255.255.0 1.1.1.2ip route-static 3.3.3.0 255.255.255.0 1.1.1.2 ############# RT1 ########### #### syssysname RT2int Eth0/0/0ip add 2.2.2.1 24ip route-static 1.1.1.0 255.255.255.0 2.2.2.2ip route-static 3.3.3.0 255.255.255.0 2.2.2.2 ############ RT1 configuration ############### syssysname RT3int Eth0/0/0ip add 3.3.3.1 24ip route-static 2.2.2.0 255.255.255.0 3.3.2ip route-static 1.1.1.0 255.255.0 3.3.3.2 ## ########### SW configuration ############### sys www.2cto.com sysname SWvlan 2 vlan 3int Eth0/4/1 p v 2int Eth0/4/2 p a v 3int vlan 1ip add 1.1.1.2 24int vlan 2ip add 2.2.2.2 24int vlan 3ip add 3.3.3.2 24 author txwhchu