PS Convert Digital Film to film (partial Japanese system)

When you are facing the beautiful sea view of Hainan Island, I believe you will not stop holding the shutter hand! The bright red sun from the sea and the bright sunset in the evening are the favorites of many photographers!

But! At that time, many people, in order to avoid the photo accidentally out of the mirror of the passers-by, I had to head the sun and model "splashing" at the seaside!

Okay, here we are. We are now using the majority of the digital machine to C and N home majority, but sometimes see the effect of film machine is also very attractive, hand itch also want to try how to do? So, the answer comes, now we use the powerful PS in a few steps to complete!

Here are a few sets of originals and complete graphs in contrast.

To tell the truth, the weather that day is not very good, a little gray, the photos look very dirty, not refreshing thoroughly! Every time we see a picture, we must learn to analyze its good and bad, not just composition, photo color, the characters show the feelings are very important, sometimes even more important than the composition!

We first import the original piece PS, and then analyze the photos, when you take photos of the effect has been roughly reflected in your mind, you have to do is to use PS to render it out! It says this picture looks very dusty, not fresh and thorough! We'll find a way to adjust it.

I took pictures without assistants, are a person completed, it is not possible to take pictures while using a reflector to fill the light, so the photo of the characters will sometimes appear yin and yang face or some place exposure of the situation! I believe many photography enthusiasts have also encountered this problem.

We first adjust the original piece, hold down the ctr+atr+2, extract the highlight, and then adjust the contrast, I am accustomed to the exposure of the place to reduce the brightness, the parameters according to each photo to set.

Next, the brightness contrast adjustment layer is copied one layer, press and hold ctrl+i to reverse, this step will brighten the dark, the specific parameters according to the photo. Well, the general lighting adjustment is complete, the next is the focus!

The original film is red and yellow, we create a new graph layer. The red is lowered, the green increases, and the blue pulls a S-shape.

The effect after adjustment.

But the whole picture looks a bit flat, we create a new graph layer to pull down the gradient, make a dark corner. The photo looks so much fresher!

The next step is critical! I create a new color level adjustment layer, from the color gradient inside the color to adjust the permeability! or from red, green and blue! The specific parameters are based on the photo.

Adjustment after the effect! is not a lot of change!

Now the whole picture's tone is basically set! And then just go for the film effect!

Create a new blank layer, fill it with white, and then click Filter-Noise-add noise, depending on the effect. Next, change the layer mode to overlay, adjust the transparency, and blur the layer Gauss, the value should not be too large, generally 2 to 3. This step is to blur the granular shape, so that it does not look so obvious!

Then copy the layer one layer and change the layer mode to multiply! Adjust the transparency, this step is to slightly darken the picture. Make it biased film effect.

Well, the whole picture of the adjustment is basically done, if you want it more on the Japanese line a little, add some Japanese watermark!

Category:

• PS Palette Tutorial