Final effect Diagram
Figure 00
Original
Figure 01
1, Photoshop Open the material picture, press CTRL + J
Copy the background layer, get "Layer 1", click on the red circle to create a new layer 2, placed between the layer 1 and the background layer, fill their favorite color as a check effect and a new background layer, you can also directly add your favorite new background picture.
Figure 02
2. Perform in Layer 1: Filter > Extract.
Figure 03
3. Use the high-light tool to apply color filter, brush size 5, fill in the middle part with the Fill tool blue.
Figure 04
4, the character of the main body to pull out, then pay attention must use eraser to clear off the edge of the noise to keep the picture clear.
Figure 05
5, new Layer 3, placed below the layer 1, select the Pen tool as shown below.
Figure 06
6, turn off the layer 2 small eyes, with the pen tool in the hair texture to do the path.
Figure 07
7. Select the Brush tool, bring up the Brush Setup Panel, set the parameters, and make sure the foreground color is set to black.
Figure 08
8, the brush set to 1, hardness of 0%, click Layer 3, enter the path, click on the upper right corner of the small triangle, select "Stroke path", in the Stroke Path dialog box below tick "simulated pressure." Click OK to delete the path.
Figure 09
9, back to Layer 3, the opacity of the layer is set to 50%.
Figure 10
10, copy background layer to get a background copy, placed between Layer 2 and Layer 3, in the background copy layer execution: filters > Extraction.
Figure 11
11. Force the foreground to tick, the eyedropper tool takes the color at the red point of the diagram, uses the high light tool to apply the green on the diagram, the brush size 50.
Figure 12
12, fine hair on the completion of the pick, in order to reflect the effect of the background copy layer opacity set to 70%.
Figure 13
Final effect Diagram
Figure 14
Category: