PS Repair diagram, most PS tool will be in the picture edge source left a lot of raw edges such as:
This time a lot of novice shopkeepers will be very bitter brain, will return to the original image of the repeated revision map. But the results are not satisfactory, of course, some shopkeepers may have other methods.
In fact, not so troublesome, only four steps, the raw edges will become smooth,
The first step: in the PS selected you need to go to the raw edges of the picture, the magic wand tool can be used to Select the image space, and then reverse selection is faster and easier.
Step two: When selected, click the Add layer mask above on the layers panel. The layer above will become .
Step three: This step is very important, with filter/blur/Gaussian blur, the inside RADIUS value can be adjusted freely, if the novice can try a few more. And then determine.
This time if you adjust the parameters of the correct, the image of the raw edges should have been lost.
PS Repair Map--Four steps to repair the image after the raw edge