PS How to give photos to the Hollywood blockbuster effect

PS How to give photos to the Hollywood blockbuster effect

Analysis before processing in the hands of a photo, we must first calm down to think about the advantages and disadvantages of this film, this is very important, this will determine the direction of your later and the expression of the effect.

Take this photo as an example, this picture because of indoor shooting, indoor and outdoor light than too large cause metering problems, so the window has been exposed, and the characters are also dark. So to find out the inadequacy of it, we can proceed to the first step of processing.

In the late step 1, the personage exposes insufficiently, then may use "the curve" and "the level" to carry on the light, the step-by-step processing until oneself satisfies. I personally use "curve" and "shadow/highlight", the reference settings are as follows:

2, feel the exposed place a pale not good-looking, so on the Internet to find the right material to fill up. Because I wanted to deal with the Hollywood-style war movie feeling, I chose a dump map as the material. Use "Quick selection Tool" To select White, and then drag the material directly into the area, properly rotate the material to the best position, and then choose "Multiply" layer mode, or with a mask, as long as the synthesis of lifelike. Finally, highlight the material layer photo exposure value, there is a window of the feeling of the scenery out, but not too much exposure, otherwise this step to deal with the loss of meaning

3, after processing the effect is not enough, there is no Hollywood film that dazzling light feeling. Then we use the Light Factory plug-in tool for fiber rendering. As for the parameters and why they use this light, these are purely personal sensations, and the specific needs of the photos, and then adjust themselves to the appropriate location. Here must pay attention to the original image of the direction of light and shade, can not reverse its path.