PS How to use high frequency to remove messy hair

PS teaches you to use high frequency to remove messy hair

I have already set the tone in the LR, and now open the picture directly in the PS.

The following figure ① the continuous replication of two layers, the above name: High-frequency, the following name: Low-frequency. ② Click on the low-frequency layer, select Filter-Blur-Gaussian blur, the value is generally 3-9, can be adjusted according to the picture. My choice here is 3.5. Next select High-frequency layer, click on image-Apply image, then appear ③ prompt box, as shown in the diagram to change the layer to: low-frequency, blending mode is: minus, scaling to: 2, the compensation value is: 128. ④ last change the layer mode to: linear light.

So you can start to pick the hair silk, select the Low-frequency layer, with the repair tool around the hair of the place dragged to the side without hair intact skin. Because the low-frequency processing color, high-frequency processing of the details of the principle (specific reasons can be Baidu) can be seen ① with a repair tool or will leave a black line, this time can jump to high-frequency layer, and then do the same action with the Repair tool, in the ③ can be seen this can be the hair silk removed.

The same operation is repeated, switching between low-frequency and high-frequency layers, and the patching tool drags hair-like skin to cover the place without hair. There must be patience here, 1.1 o ' time slowly. There are some eyes and the hair around the mouth temporarily do not handle. After completing this step you can get the following figure, you can see the face of the treatment of the uneven color of the place, there are some flaws. This time can be used to wear skin plug-ins: Portraiture in the low-frequency layer to open the grinding plug, grinding once if the effect is not obvious can be more grinding several times.

Finally, to deal with the hair just above the eyes and mouth. Stamping a layer, select the Clone Stamp tool, opacity for 20%,ps: here to remember that the opacity can not be too high, rather 1.1 points slowly. After the completion of this step, the hair is finished.

That's all the steps in this tutorial. Then do the other details of the fine repair, here is not to elaborate. Finally put a picture of the repaired.

Category:

• PS Image Processing