PS Making water polo with transmission light effect

1. Create a new file in Photoshop, 100x100 size, RGB mode, background color fill #006666, add a layer, build a 80*80 circle, fill the white result as shown in Figure 01:

Figure 01

2.02copy to the upper layer of the white circle and select Layer/group with previous move the watermark picture to the figure 03 position with the Move tool

Figure 02

Figure 03

3. With the size of "100" Eraser Tool wipe the left and the lower side, the transparency is set to "50%", and then with a smaller Eraser Tool wipe round the border, in short, the final can be achieved as a result of the figure 04.

Figure 04

4. Add a layer, with airbrush Tool inkjet round close to the right part of the foreground color set to black, airbrush transparency can be set to 20-40, size can be used 35 or 45th of the pen, in short, the final can be achieved as a figure 05 effect.

Figure 05

5. Add a layer, draw a 20*12 large oval, fill the white, turn the ellipse to the right 45 degrees angle, and then placed in the position shown in Figure 06, I again on its edge dot a few white dots, so that there seems to be a few bubbles around

Figure 06

6. Add a layer, draw a 80*80 white circle, and then use Cut method to get the White Crescent line as shown in Figure 07, in the same way, I drew a smaller white Crescent line, placed on the left position as shown in Figure 07

Figure 07

7. The layer with white crescent lines is set to transparency is 40% is like the translucent effect of Figure 08, finally, I added a less strong column shadow.

Figure 08

This tutorial does not put every detail steps are very clear, but only for a simple production process introduction, hope that interested netizens can study this lovely water polo.