PS Pictures plus a soft blue-yellow tutorial

This tutorial has a simpler palette, with the main color blue and orange yellow. When processing, only to the dark part and the midtones of the color to blue, the high light part of the color can be adjusted to warm.
Original

< small map view big picture >

Final effect

1, open the original material, create an optional color adjustment layer, yellow, green, green, white, black to adjust, parameter settings such as Figure 1-5, the effect is shown in Figure 6. This step turns the background leaves green to blue.

< map 1>

< map 2>

< map 3>

< map 4>

< map 5>

2, press CTRL + J to copy the current optional color adjustment layer, the opacity to: 40%, the effect of the following figure.

< map 7>

3, create color balance adjustment layer, shadow, highlight adjustment, parameter settings such as Figure 8,9, the effect is shown in Figure 10. This step puts the high light part in a warm color.

< map 8>

< map 9>

4, press CTRL + ALT + ~ To bring up the high light selection, press CTRL + Shift + I to select a new layer fill deep blue: #330C4E, blending mode to "soft light", the opacity to: 30%, the effect of the following figure. This step adds blue to the dark part of the picture.

< map 11>

5, create curve adjustment layer, to the blue adjustment, parameter settings, such as Figure 12, to determine the layer opacity to: 50%, the effect is as Figure 13.

< map 12>

6, create a new layer, press CTRL + ALT + Shift + E-stamped layer. CTRL + Shift + U go color, blending mode to "multiply", opacity to: 40%, alt key to add layer mask, with a white brush to the bottom of the dark part, the effect of the following figure.

< map 14>

7, use the Lasso to check out the face selection, press CTRL + ALT + D Feather 2 pixels after the creation of color balance adjustment layer, slightly adjust the color, and then the appropriate brightness, the effect of the following figure.

< map 15>

8, a new layer, stamped layer. Simple to rub the skin of the characters, the general effect of the following figure.

9, a new layer, fill orange yellow: #FB951B, blending mode to "filter", hold down the ALT key to add a layer mask, with a white brush to the upper left corner of the section, the effect of the following figure.

< map 17>

10, create a color balance adjustment layer, the high light adjustment, parameter settings such as Figure 18, after the layer to determine the opacity to: 40%, the effect of Figure 19.

< map 18>