PS Pull Digital portrait texture of black and white effects

Final effect Diagram

Figure 00

1, the original effect is good. This article is mainly to explain the black and white image processing ideas. Open the image in PS, as shown in the following figure:

Figure 01

2, select/Color range, select "High Light" after the high light selection, and then establish a curve adjustment layer, the following figure:

Figure 02

3, the curve adjustment layer opacity properly lowered, or too bright, the following figure:

Figure 03

4, adjust the brightness contrast, the overall tone of the portrait to brighten some.

5, reduce portrait saturation, so that the hue/saturation command adjustment, due to the adjustment is too large, appropriate reduction of opacity, the following figure:

Figure 04

6, the establishment of black and white adjustment layer, the main adjustment of red and yellow, because the color of the characters mainly for these two colors, the following figure:

Figure 05

7, after the adjustment, found that the screen is too dark, so appropriate control of the image cold, which is to adjust the black and white portrait of a key step, the following figure:

Figure 06

8, in order not to let the picture too cold feeling, you can try to portrait high light appropriate to add warm, the following figure:

Figure 07

9, the screen is also appropriate adjustment of neutral color, the following figure:

Figure 08

10, in order to more prominent characters, so that the black and white radial gradient, and then add layer mask, apply white black radial gradient, and change the layer mode to soft light mode, the following figure:

Figure 09

11, the establishment of brightness/contrast command, this step special attention, the purpose is to let some of the light, so highlight a texture, a lot of black-and-white image is the pursuit of this effect, but a lot of contact with the digital enthusiasts, that this is loss details, actually, the effect of the following figure:

Figure 10

12, note that this brightness/contrast layer attention on the graph layer above, do not put the wrong position, the following figure:

Figure 11

13. If you want to recover hair details, apply a gray brush to the brightness/contrast layer mask. Note that this case effect does not take this step. The final effect is shown below:

Figure 12

Category:

• PS Image Processing