PS to create a beautiful gift box

When making, you can first draw a draft map, pay attention to the effect of good perspective. And then make each of the various faces. It might seem like a copy, but it's pretty simple to make.

The Gift box is a three-dimensional graphic, roughly composed of two large faces. When making, you can first draw a draft map, pay attention to the effect of good perspective. And then make each of the various faces. It might seem like a copy, but it's pretty simple to make.

Final effect

1, a new 600 * 600 pixel document, background fill white. Create a new layer, use the pen to tick the trapezoidal selection shown in Figure 1, select the Gradient tool color set to 2, and pull out the linear gradient shown in Figure 3.

Figure 1

Figure 2

Figure 3

2, create a new layer, with a pen to check out the selection shown in the following figure, fill color: #54812E.

Figure 4

3. After multiple layers, select the selection shown in Figure 5 of the Rectangle Marquee tool selection and pull the linear gradient shown in Figure 6.

Figure 5

Figure 6

4, create a new layer, with a rectangular marquee tool to pull a thin rectangular selection, fill white, change the opacity of the layer, with a white brush to the ends of a little bit dot point out, the effect is shown in Figure 8.

Figure 7

Figure 8

5. Create a new layer and use the pen to check out the selections shown in Figure 10 and pull the linear gradients shown in Figure 9.

Figure 9

Figure 10

6. Create a new layer, and use the rectangular tool to pull out the rectangular selection shown in Figure 11, fill the color: #B27701.

Figure 11

7. After locking the layer, select the above section with the rectangular marquee tool, as shown in Figure 13, and pull the linear gradient in Figure 13.

Figure 12

Figure 13

8. Select the following section with the rectangular selection box and pull the gradient.

Figure 14

9, again the middle part, the method ditto, the color sets the following picture.

Figure 15

10. Create a new layer, and use the pen to check out the selections shown in Figure 16, fill the color: #DB9B15.

Figure 16

11, lock the layer with the pen tool to check out the selection shown in Figure 17, pull on the gradient, pull the gradient, do not cancel the selection. Press CTRL + Shift + I to reverse the selection and pull the gradient, as shown in Figure 18.

Figure 17

Figure 18

12, the left side of the copy of the past is OK.

Figure 19

13, the same method of making the other parts of the bow, the effect of the following figure.

Figure 20

14, this step to make some surface folds, with a gradient can be, the effect of the following figure.

Figure 21

15, make shadow, method optional, the effect of the following figure.

Figure 22

16, the final plus background gradient, complete the final effect.