Puling tl-wn721n V1.0 How to install the wireless network card

General tl-wn721n V1.0 installation method for setting up wireless network card

The first step, the preparation of wireless network card and Driver

Method One, the wireless card installation CD into the computer optical drive, and the wireless card plug into the computer's USB interface. Turn on my Computer (computer) and locate the DVD drive. Right-click to open to see the contents of the disc.

Method II, if unable to find the installation of CD-ROM or computer optical drive can not be used, need to download the corresponding driver in our official website.

Step two, install the wireless network card and the client

Open the driver file, which contains the following contents.

Double-click Setup.exe to run the software, the following interface appears, and click Next, the following figure.

Select Install client applications and drivers, click Next, as shown below.

The installation path remains the default, click Next, as shown below.

The program folder also remains the default, and click Next, as shown below.

Select Tp-link Wireless client application [TWCU] and supplicant, and click Next, as shown below.

Attention. If Windows appears with security prompts, follow these steps.

Displays the installation progress, as shown in the following figure.

Prompt to complete, select Yes, restart the computer now, and click Finish, as shown below.

At this point, the wireless network card driver and client Software installation was successful.

Step three, connect to the wireless network

After the computer restarts, double-click the desktop to run the Tp-link wireless client application, as shown below.

Click Profile Management, and click Scan, as shown below.

Select your wireless signal (this example is Zhangsan) and click Activate, as shown below.

Attention. There is a key behind the network name, as shown above, the wireless network is encrypted and you need to enter a wireless password to connect.

Pop up the following interface, in general, the configuration file name can be arbitrarily filled out, in this case set to the same as the SSID is Zhangsan, the following figure.

Then click Security, select the Wireless encryption method WPA/WPA2 passphrase, and click Configure, as shown below.

Enter the wireless password in the pop-up interface, click OK, as shown below.

Back to the Profile management interface, click OK again, as shown below.

Click on the current status, you can see the success of the wireless connection, and display the IP address and signal strength and other information.

The wireless card is successfully connected to the wireless network.