Pycharm sometimes pops up edit configuration solution when opening engineering files

Because it is a small white, so loaded TensorFlow, accidentally, do not know what, next to the start bar did not, how to adjust all out, so far not resolved this problem, in the instigation of the friends, directly reload Ubuntu, first installed Anaconda, after the Pycharm, I don't know if that's the reason, it is found that when the project file is reopened, the Edit configuration Configuration box will pop up, and every module will pop up, as follows: (PS: Because very lazy, too lazy to cut screen, borrow this small brother's figure a use, write a solution, the head melon is not very good, Afraid to go to England bitter forced to read to forget, write down

The reason is that the Python interpreter is not configured for this project, as follows:

1. Open the settings under File

2. Locate project interpreter under project:unititled and locate the corresponding engineering file on the right, and you can see that project interpreter is set to NULL

3. Select the corresponding Python interpreter, click Apply (the necessary steps), click OK, Setup completed, this project file can be performed normally

Get...

Because of laziness, directly copy this little brother's.

thanked here.

Look at the original Bo, click here

Https://www.cnblogs.com/kakaln/p/8319133.html

Attach a link address, aha haha.