[Email protected]:~# IW listwiphy phy0 max # scan SSIDs:4Max Scan IEs length:2257bytes Retry ShortLimit7RetryLongLimit4Coverage class:0(up to 0m) Device supports RSN-IBSS. Device supports AP-side uAPSD. Device supports T-DLS. Supported ciphers:* WEP40 (xx-0F-AC:1) * WEP104 (xx-0F-AC:5) * TKIP (xx-0F-AC:2) * CCMP (xx-0F-AC:4) *xx-0F-AC:Ten* GCMP (xx-0F-AC:8) *xx-0F-AC:9* CMAC (xx-0F-AC:6) *xx-0F-AC: -*xx-0F-AC: One*xx-0F-AC: AAvailable antennas:tx0x1Rx0x3configured ANTENNAS:TX0x1Rx0x3supported interface modes:*IBSS*managed*AP* ap/VLAN*WDS*Monitor*Mesh Point* p2p-Client* p2p-GO Band1: Capabilities:0x116eHT20/HT40 SM Power Save disabled rx HT20 SGI RX HT40 SGI Rx STBC1-Stream Max amsdu length:3839bytes DSSS/CCK HT40 Maximum RX AMPDU length65535Bytes (exponent:0x003) Minimum RX AMPDU TimeSpacing8USEC (0x06) HT TX/RX MCS Rate Indexes supported:0-7bitrates (non-HT):*1.0Mbps*2.0Mbps ( ShortPreamble supported)*5.5Mbps ( ShortPreamble supported)*11.0Mbps ( ShortPreamble supported)*6.0Mbps*9.0Mbps*12.0Mbps*18.0Mbps*24.0Mbps*36.0Mbps*48.0Mbps*54.0Mbps Frequencies:*2412MHz [1] (16.0dBm)*2417MHz [2] (16.0dBm)*2422MHz [3] (16.0dBm)*2427MHz [4] (16.0dBm)*2432MHz [5] (16.0dBm)*2437MHz [6] (16.0dBm)*2442MHz [7] (16.0dBm)*2447MHz [8] (16.0dBm)*2452MHz [9] (16.0dBm)*2457MHz [Ten] (16.0dBm)*2462MHz [ One] (16.0dBm)*2467MHz [ A] (16.0dBm)*2472MHz [ -] (16.0dBm) (No IR)*2484MHz [ -] (disabled) supported commands:*New_interface*Set_interface*New_key*Start_ap*new_station*New_mpath*Set_mesh_config*SET_BSS*Authenticate*Associate*deauthenticate*Disassociate*JOIN_IBSS*Join_mesh*Remain_on_channel*Set_tx_bitrate_mask*Frame*Frame_wait_cancel*Set_wiphy_netns*Set_channel*Set_wds_peer*Tdls_mgmt*Tdls_oper*probe_client*Set_noack_map*register_beacons*Start_p2p_device*set_mcast_rate*Channel_switch* Unknown Command (104) *Connect*Disconnect supported TX frame types:* IBSS:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* Managed:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* AP:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* Ap/vlan:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* Mesh point:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2p-client:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2p-go:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2p-device:0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0supported RX frame types:* IBSS:0x40 0xb0 0xc0 0xd0* Managed:0x40 0xd0* AP:0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0* Ap/vlan:0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0* Mesh point:0xb0 0xc0 0xd0* P2p-client:0x40 0xd0* P2p-go:0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0* P2p-device:0x40 0xd0software interface modes (can always be added):* ap/VLAN*Monitor valid interface combinations:* #{Managed} <=2048, #{AP, mesh point} <=8, #{p2p-client, p2p-go} <=1, Total<=2048, #channels <=1, sta/AP BI must match* #{WDS} <=2048, Total<=2048, #channels <=1, sta/AP BI must match HT Capability overrides:*MCS:FF FF FF FF FF FF FF FF FF* Maximum A-MSDU Length*Supported channel width* ShortGi for +MHz* Max A-MPDU length exponent*min mpdu start spacing Device supports TX status socket option. Device supports HT-IBSS. Device supports SAE with authenticate command Device supports low priority scan. Device supports scan flush. Device supports AP scan. Device supports per-vif TX Power setting peer GO supports CT window setting Driver supports a userspace MPM Device supports active Monitor (whichWould ACK incoming frames) Driver/device bandwidth changes during BSS lifetime (Ap/go mode)
Qualcomm Atheros qca9565/ar9565 Wireless Network Adapter (rev 01)