Quartus II 12.0 and Modelsim 10.1 se installation and connection

Quartus II After 10.0 did not have their own simulation software, each time a veriloghdl to write a simple simulation, the results found that no self-brought simulation software. Third-party simulation software Modelsim 10.1 SE is required.

Quartus II Installation and cracking

1. Download Quartus II and quartus II hack patch. Find Baidu, Baidu is not on the official website to register to download.

2, first, install Quartus II. Next-->next-->finish. 64-bit system installed 64-bit, 32-bit 32-bit, there is a problem is Quartus II 14.0 after only 64-bit, it is recommended that 2G memory below do not install 64-bit system, the above can upgrade the 64-bit upgrade.

3, decompression Quartus II crack patch.

4, there is a Quartus II XXX.exe file, is often considered a virus and was mistakenly deleted. Copy, and put it under the Altera\12.0\quartus\bin.

5, click on it, and then click Apply.

6. Save the License.dat and replace the XXXXXXXXXXXX with the NIC ID of Quartus II (note: There are usually more than one, either), the ID is found in license setup under Quartus's Tools menu.

7, Quartus II Under the Tools menu Select License Setup, and then select License file, select to License.dat, click OK, crack complete.

Modelsim 10.1 Installation and cracking

1. Download Modelsim 10.1 se version and its cracked file

　　

2. Install Modelsim 10.1 se version

The installation process will appear if Hardware Security Key Driver is selected. There is a need for a permit, no.

　　

3, the cracked file has two files, MentorKG.exe and Crack.bat, copy it to the Modeltech_10.1a\win32 directory.

4, click Crack.bat, generate TXT file, save as LICENSE.TXT, put under Modeltech_10.1a\

5, add the environment variable lm_license_file, the path is ***\modeltech_10.1a\license. Txt

At this point, the hack is complete.

In the next one is how to connect two software.

1. Select the Tool-->options-->general-->eda Tool options in Quartus II and add its path in Modelsim ***\modeltech_10_1a\win32

2, select the Assignments-->eda tool options-->simulation in Quartus II, select Modelsim in Tool name (Note: Do not select Modelsim-altera). Below it is a run Gate-level simulation automatically after complication, which opens Modelsim for compilation after synthesis. We recommend that you do not choose first.

3, after the comprehensive compilation, click Processing-->start-->start Test Bench template Writer can automatically generate testbench templates. The Testbench file is under the Simulation\modelsim of the project file.

4, Write good testbench, enter Assignments-->eda Tool options-->simulation, in Nativelink settings select Compile test bench and select the corresponding testbench file.

5.

The file name of the. vt file and the top-level entity module name in the. vt file

6, click Tool-->run Simulation TOOL-->RTL simulation for simulation.

Now that Quartus II and Modelsim 10.1 are connected, the next step is to consider how to write the Testbench.

　　

Quartus II 12.0 and Modelsim 10.1 se installation and connection