Quickly learn how to set a Broadband Router

For public users, it is very important to understand some Broadband Router setting methods. So I have studied the Broadband Router setting methods and will share them with you here, hoping to help you. Set the IP address and router management address of a computer in the same CIDR block. Enter the default management account and password in the Broadband Router specification to go to the configuration page.

To enable the router to automatically dial, we also need to integrate the ADSL account into the router. Click the "Homepage" tab on the top, and then click "WAN" as the change. The location where the ADSL account is set is displayed in the PPP over Ethernet, enter your own ADSL account and password and save the settings. Now, go to "system information" in the "system status" tab to check the network status, on the WAN side, you can clearly view the network information obtained by ADSL dialing.

After configuring the ADSL account, we can access the Internet through the Broadband Router. However, to better manage and improve security, you need to perform the following operations: click the "Homepage" tab, select "DHCP" on the left and set the ip address range in the ip address range that the DHCP server can enter. After saving the settings, the Broadband Router can automatically assign ip addresses.

One of the methods for setting a Broadband Router is to prevent bt flooding attacks.

By default, all computers connected to the Broadband Router setting method are protected. That is to say, if they are in the Intranet, the use of p2p software such as bt will be affected. We can use "DMZ" in the "Advanced Settings" label to set the declared host. The host set up here is exposed in the network. On the one hand, you can use bt to download software and create iis and ftp servers without any concerns, and on the other hand, it is also exposed to hackers and viruses, therefore, the security of the computer must be well done. It would be unwise to declare the host only to use p2p software such as bt. In fact, we can use the upnp function to solve the problem that p2p software cannot be used in the intranet. You can click "Other Projects" under the "Tools" tab on the "configuration method" interface of the Broadband Router, and set upnp to "start .)

Go to the filter tag in the configuration method interface of the Broadband Router. We can filter the source and address of the datagram, including IP address, url Information, mac address, and region information. Set "Activate" ip address filtering, and enter an IP address within the IP address range, for example, 192.168.0.111. Port information is actually entered in the "port range" field. Because bt downloads ports 6881 to 6889, We can filter them here. Select tcp for "protocol" and "Schedule" to set the time when the filter takes effect depending on the actual situation ).

Method 2 of setting a Broadband Router: Service and Security

Hackers and viruses exposed to the internet may exploit vulnerabilities to attack computers. In fact, we can solve this problem by setting up virtual servers. Log on to the Broadband Router configuration interface. Select the virtual server tag on the Advanced Settings page. Activate the virtual server settings and enter the relevant virtual server information. For example, if we want to allow the computer 192.168.0.112 to provide the ftp service, but want to protect other ports with the Broadband Router setting method, we can simply virtualize the ftp service. Set the personal IP address to 192.168.0.112, the Protocol mode is tcpftp service uses tcp), and the personal port 21ftp uses port 21 ). In addition, you can set the time period for this virtual service to take effect in the "arrange" area.