Tutorial Artwork
10% effect after amplification
1: In PS open to enlarge the picture;
2: New Action;
3: Right click on the top of the picture to select the size of the image in the dialog box that appears as shown in the figure red box, note two places: one is to check the "Reset Pixel", and the interpolation method set to "two cubic", the second is to set the size of the document unit as a percentage, and only to use the percentage of 110, which will increase the image 10 %。 Believe it or not, when you increase the image in increments of 10%, it does not seem to blur and soften the image for some reason. It's strange and interesting.
4: Press "OK" button, the image is increased by 10%, the action is completed, and then press the action below the Stop Play/Record button, that is, action completed,
5: Selected to do the 10% magnification picture action, and then click the following play selection, each click, the picture will increase 10%, if there are other pictures to enlarge, directly apply this action on it, very convenient.