Description:
1, in the actual project, many times, we need to the sensor or ADC values in the form of waveform display. The usual solution is to use the serial port host computer, USB interface host computer or MDK logic Analyzer function, using these three methods are more cumbersome. This issue for you to explain the J-scope waveform software is simple and easy to use.
2. J-scope waveform display software mainly has RTT and HSS two ways of working. This topic is a tutorial on how to use RTT mode. RTT mode waveform display is very fast, and can connect the target board anytime, anywhere, without affecting the normal function of the target board, no need for additional resources. You can also set the rising edge, falling edge, or double-edge trigger.
3, everyone bought the D version of Jlink, Basic is from Jlink base, need to use V9 or V10 version of the line. Jlink Pro or Jlink Ultra uses V4 and above.
4. The HSS model of J-scope Special tutorials has been explained in the 4th issue of the tutorial. ,
5, more relevant content and considerations, see the tutorial can be.
Featured Tutorials Download:
Featured Tutorials Phase 6th: J-scope waveform software usage (bottom). pdf (1.34 MB)
supporting examples (including MDK and IAR):
STM32F103ZET6 Development Board: RTT mode for v4-j-scope waveform software. 7z (957.58 KB)
STM32F407IGT6 Development Board: RTT mode for v5-j-scope waveform software. 7z (2.11 MB)
STM32F429BIT6 Development Board: RTT mode for v6-j-scope waveform software. 7z (3.06 MB)
Tutorial Directory:
The GIF picture effect of RTT:
Not set trigger, 200KHz upload speed, 16-bit data, speed corresponds to 400kb/s (upload speed in the lower right corner).
Set trigger, 200KHz upload speed, 16-bit data, speed corresponds to 400kb/s (upload speed in the lower right corner).
One more dynamic adjustment effect:
"A special tutorial 6th" Segger j-scope waveform host computer software, RTT mode waveform upload speed can be around 500kb/s