The fifth chapter of "Android Deep Exploration" is about setting up a test environment for the s3c6410 Development Board. 1. Install Serial debugging tool: Minicom, 1th step: Use Insmod | The grep usbserial command detects whether the current system supports USB to serial port, 2nd step: Install minicom using the Apt-get install minicom command, step 3rd: Configure Minicom–s with minicom command ; 4th step: Test minicom with the minicom command 2. Burn Write Android system: (1) Use Eboot erase Nandflash method: 1th Step: Prepare work, use serial line or USB to serial cable to connect Development Board and PC, and start minicom; 2nd step: Enter eboot State; 3rd step: Erase Nandflash. (2) Burning Android steps: 1th step: Prepare to work, prepare a 2GB or 4GB SD card, require FAT32 partition format, insert card reader and connect PC, 2nd step: Write Mmc.bin and zimage-sd.bin to SD card; 3rd Step: Prepare for the pre-written Android, step 4th: Start burning Android from SD card, 5th step: Calibrate the screen. 3. Configure the Wired network.
By studying the fifth chapter, I know that the development Board is the main hardware device for developing and learning embedded technology, although the Linux driver can be developed on the PC and then recompiled into the Linux driver module of the ARM architecture, but it will be tested on the development Board eventually. In Building s3c6410 Development Board test environment, and build other environment similar, may encounter a lot of problems, encountered problems is not anxious, to actively find ways to solve the difficulties, to believe that the method is more difficult than. Can be found through the search of relevant data on the Internet solution, really do not seek the help of classmates, if still can't solve the problem, can seek teacher's help, the teacher is our study refers to passers-by, we can find a solution to the problem.
"Android Deep Exploration" fifth chapter experience