************************************************************************ ****原文:blog.csdn.net/clark_xu 徐长亮的专栏 ************************************************************************
Directory
1 Introduction ... 1
2 boot ... 2
3 DS Storage Manage create resource pool ... 3
3.1 in Hmcmanage, start DS storage MANAGER.3
3.2 Jian Raid.4
3.2.1 Array Site.4
3.2.2 Array.4
3.2.3rank.6
3.2.4 Extent POOL6
3.2.5 Partition volume (LV) ... 7
The establishment of 3.2.6 VG ... 9
The establishment of 4.host ... 11
The establishment of 4.1 host ... 11
4.2 IO ports.12
4.3 Host connection ... 12
5. Configuration Complete ... 13
Note: I took a lot of pictures, temporarily do not upload. A friend who needs detailed pictures, can contact me 1 introduction
IBM ds8100 is an early release of IBM storage. The composition of the IBMds8100: two small machines (as controllers), the hardware Management controller HMC (one 1U server as a console with a monitor), 96 hard drives, another power supply PPS (controlled by the Uepo emergency button), a UPS, four IO cabinets (each port on the IO cabinet is equivalent, As long as there is a port connected to the host can be identified) front view
2 boot
Power two PPS switch: On (yellow putt online) A switch, at remote location 380V power, in front of PPS (power) on the display of PPS AC input good
Turn on the emergency switch (UEPO): Use a pin to keep the top side down. PSS (Power) lamp Uepo Lood good.
Boot HMC (1u Management Server):
Access to the HMC's software console:
Pull out the monitor: Enter the system auto eject Software console, click DS Storage Manager
Enter username password: ce password: serv1cece
Through the HMC Open two small machine (Controller), complete the entire storage boot.
In DS StorageManager Click Storage:server View and see two small machines as controllers. Can be started directly on the power supply, or it can be started at the HMC console:
3 DS Storage Manage create a resource pool.
3.1 in Hmcmanage, start DS Storage Manager,
In the setting up of the DS storage Managerd, there is an interface that will always exist, cannot be closed, don't care about her
Minimize the window, right-click the shortcut menu on the desktop, select the HMC browser, and go directly to the DS Storge Manager interface.
Enter Username: admin Password: passw0d (24 hours have three times the opportunity to enter a password, otherwise locked account, general IBM engineers will turn off this feature
3.2 build raid 3.2.1 Array site
A row of 16 hard drives, the first eight blocks, and the last eight pieces. An array site is an eight-piece hard disk, as shown in the above number
S1 S2 S3 S4 is an array site, the first four blocks after four pieces.
each array set (S1-S12) can only establish an array. 96 disk, 12 array site 3.2.2 Array
Each array must be within an array set, and only eight disk configurations.
This storage supports RAID 5 RAID 6 raid 10
If you select Raid 5,array set s1-s8 default is 6+p (check disk) +s (hot spare)
Array Set S9-S12 default is 7+1 (check disk)
Default A0–a11
If you add it directly to the ranks by default, you do not need to add it next.
3.2.3rank
The format of an array becomes a rank. We set to FB mode (a data block (stripe) is 1GB)
Default is R0-r11
3.2.4 extent pool
Establishing a resource pool for logic Vlome