"Just 3 steps" Linux PHP installation and Configuration Manual security Kit

Author of wavelet/qq463431476 welcome reprint!

Linux:redhat 6/centos 6

Proceed to the previous note for Apache configuration http://www.cnblogs.com/xiaobo-Linux/p/4637056.html, and then record the Linux installation PHP process below.

First step: Install the dependent package Libxml2,libxml2-devel

If not installed, the following error will occur during the installation of PHP:

Configure:error:xml2-config not found. Please check your LIBXML2 installation.

So first install the dependent package with Yum:

Yum install Libxml2yum install LIBXML2-devel

The second step: download, unzip the PHP installation package, and the configuration of PHP:

: http://www.php.net/downloads.php
Unpack the installation package:

TAR-ZXVF +php Bag

Go to unpack folder to execute:

./configure--prefix=/work/installed/php  --with-apxs2=/work/installed/apache/bin/apxs

Where:--with-apxs2=/work/installed/apache/bin/apxs is installed after the Apache directory here is my installation directory address (depending on your situation)

Then compile:
Make
Test compilation:
Make Test
Final installation:
Make install

Configuration file:

# [Email protected]/CP Php.ini-development/work/installed/php/lib/php.ini
Copy the original php.ini-development in the source code to/usr/local/php/lib/php.ini, and rename it to PHP.ini

Re-execute the following command in the original Apache unpacking package: (This note is immediately followed by the previous note Apache configuration http://www.cnblogs.com/xiaobo-Linux/p/4637056.html)

./configure--prefix=/work/installed/apache--WITH-APR=/WORK/INSTALLED/APR--with-apr-util=/work/installed/ Apr-util--with-pcre=/work/installed/pcre--enable-module=shared

./configure--prefix=/work/installed/apache--WITH-APR=/WORK/INSTALLED/APR--with-apr-util=/work/installed/ Apr-util--with-pcre=/work/installed/pcre--enable-module=shared

To add a later parameter, you cannot use php,-enable-module=shared to indicate that Apache can dynamically load modules

Edit and configure Apache inside files

Edit the/work/installed/conf/httpd.conf file (other people have a custom installed directory/usr/local/apache/conf/httpd.conf
Found it:
AddType application/x-compress. Z
AddType application/x-gzip. gz. tgz
Add in the following:
AddType application/x-httpd-php. php

AddType Application/x-httpd-php-source. php5

The goal is to enable Apcche to support PHP

Found it:
<ifmodule dir_module>
DirectoryIndex index.html
</IfModule>
Add: Add index.php after index.html! (This has been written to Apache configuration http://www.cnblogs.com/xiaobo-Linux/p/4637056.html in the previous note configuration Apache)
<ifmodule dir_module>
DirectoryIndex index.html index.php
</IfModule>

Restart Apache: Restart in the installed Apache directory:

/work/installed/apache/bin/apachectl restart

The third step is to test PHP:

Create a text index.php file in the directory where you publish the page:

The default is to create a PHP file under Apache Htdocs index.php, which reads as follows:
<?php
Phpinfo ();
?>

My publish directory is to build index.php file under/home/web/

The test succeeds when the content appears as above!

"Just 3 steps" Linux PHP installation and Configuration Manual security Kit