"Ti layman" network knowledge note Three remote login configuration for Cisco routing switching

After the new switch is bought, all need to be simple configuration to meet the unit network operation, after the configuration of the device will need to put it where it should be placed, but in the future we need to view or modify this device, we need to use remote login to configure it. Let's talk about the specific configuration of remote login.

First, you need to use a dedicated configuration line (console line) to connect the device

Second, configure the line of another section of the connection PC,PC terminal open HyperTerminal (online download a super terminal software)

Third, enter the configuration interface: Enter command--en into privileged configuration mode

Config into global configuration mode

Interface VLAN 1 into the Vlan1 interface mode

IP Address Subnet mask configuration vlan1 IP

No shutdown Enabled

Exit exits to global configuration mode

Line vty 0 4 Configure vty telnet (0 4 means you can have 4 devices at the same time login here up to 0 15)

Password Password to configure login password

Login Registration Activation

Exit exits to global configuration mode

Enable password password Configure password for privileged mode

Or an enable secret password to configure privileged mode cipher

Four, this configuration is basically completed, the device is returned, we can telnet access, the PC to enter the command prompt interface (run input cmd), input: TELNET+VLAN1 IP will prompt for the login password, and then enter the password to login privileges mode. So we can configure the device.

"Ti layman" network knowledge note Three remote login configuration for Cisco routing switching