Raspberry Pi 2 installs Win10iot and Ubuntu mate

The blog has been registered for more than 2 years. Have not written blog now time to write.

This blog post is because I have been on the internet to find a lot about the tutorial written is not very clear. The installation was unsuccessful. So I wrote about what I found on the Internet to organize a share.

A non-professional is just an amateur play. Okay, cut the crap. Go directly to the topic:

Preparatory work:

Hardware

1, Raspberry Pi 2 (must be selected, must be Raspberry Pi 2 generation) official website: https://www.raspberrypi.org/

2, HDMI to VGA mother to computer HD Line Converter connector interface (optional, according to their actual needs to decide)

3,5V2A Special power adapter (optional, mobile phone charger can be)

4, 8G or more high-speed SD card (for burning system image. Format: FAT32)

Software

1. Win10iot ARM IoT for Raspberry Pi ii:http://www.ithome.com/html/win10/166149.htm

2, Win10 and VS2015 (I was fired with Win10, Win7, 8 has not been attempted. Online also not on the tutorial)

3. Ubuntu Mate 15.04:https://ubuntu-mate.org/vivid/

4, Win32diskimager-0.9.5-binary:http://www.onlinedown.net/soft/110173.htm

My test environment: win10+vs2015

Current Raspberry Pi 2 supported systems as well as image downloads (this article for Win10 and Ubuntu mate): https://www.raspberrypi.org/downloads/

WIN10 Iot Installation

Install WIN10 Iot mirroring directly. Installed by default on C:\Program Files\Microsoft IoT

Directory:

Dism

FFU

IoTCoreImageHelper.exe (Burning Win10iot Mirror)

WindowsIoTCoreWatcher.exe (link device information view)

---------------------------------------------------------------------------------------------------------

1, installation WindowsIoTCoreWatcher.exe

2. Select Ffu\raspberrypi2\flash.ffu Image after running IoTCoreImageHelper.exe select TD Card (note backup TD card data)

3. After firing, insert the TD card into the Raspberry Pi 2 TD card slot. Connect the HDMI to VGA mother to computer High Definition line converter connector. Re-connect the power supply.

4, the first start a little slow. Then follow the instructions to install the procedure.

5. Run after successful installation: WindowsIoTCoreWatcher.exe can see the status of your device.

：

Burn image

Start screen

Installation configuration

Setup interface

Ubuntu Mate Installation

Installing Ubuntu Mate is relatively straightforward as long as Ubuntu mate 15.04 mirrors and win32diskimager-0.9.5-binary are available.

1. Run Win32diskimager-0.9.5-binary select TD Card to write the image to boot the installation. Isn't it simple?

2, the boot step is the same as firing, the TD card into the Raspberry Pi 2 TD card slot. First connect HDMI to VGA mother to computer HD line Converter connector. Power supply again.

3, the first start a little slow. Then follow the instructions to install the procedure.

：

Boot interface

System Configuration

Successful Installation Interface

Win10iot is not very smooth, mobile mouse can sometimes appear in the phenomenon of Kaka. This Ubuntu mate does better than Win10iot. This is not the case. Open use and so on both will appear in the phenomenon. Still can't compare with the ordinary computer. Looking for post-optimization ...

As. NET programmer I'm still looking forward to Win10iot.

Not good, I was the first time to write a blog post. Please include a lot of shortcomings.

Original: http://www.cnblogs.com/mycing/

Raspberry Pi 2 installs Win10iot and Ubuntu mate