Related Technical steps for portrait post-processing basics

I. Converting a 16-bit image to a 8-bit image

1. Take the texture out of the photo to make it more real:
Filters-Sharpening-Smart Sharpening
Qty 100
Radius 1
Reduce noise 0

2.16-bit conversion to 8-bit
Image-mode-8-bit channel

Two. Contrast ratio and saturation adjustment

1. The picture looks like a piece of gray, the contrast is not enough
Add adjustment-curve-slash One-third to make an S-type

2. Picture red or some other color too much, saturation too high
Add adjustment-hue/saturation-reduce saturation

Three. Repair screen defects and spots

1. Remove large areas of stains-hair
Point Clone Stamp Tool-brush hardness set to 0-size 500-alt sampling-point or coating
Then use the patch tool to make the imitation of the place natural a little (fix)

2. Remove small areas of stains-Acne
Spot Spot Repair tool/Patch tool/Clone Stamp tool-point or apply
Remember to leave some places that are not repaired (naturally).

Four. Color correction of Makeup

1. The color of the makeup is not satisfactory

Press Q Quick Mask-point brush-front color black, back color white-apply the area to be changed
Then press Q to complete the mask-and then press Ctrl+alt+i to reverse the selection (the black place can not be changed, the white Place may change)
Click Add Adjustment (becomes an adjustment layer)

Color is not satisfactory--optional color
Lipstick level Sense-curve (can be dimmed, can also be adjusted with S-curve contrast)

Five. Correction of hair

1. Repair hair, remove excess hair, or slightly grow hair
Using the Clone Stamp tool (repeated sampling) (hard edges with focus points) (soft edges for blur points)
Using the Spot Repair tool
With Patch Tools

Six. Further correction of skin

1. Repair of skin
Using the Clone Stamp tool (repeated sampling) (hard edges with focus points) (soft edges for blur points)
Using the Spot Repair tool
With Patch Tools

Seven. Eye Detail Treatment

1. Removal of excess eyelashes and treatment of whites and eye highlights
Using the Clone Stamp tool (repeated sampling) (hard edges with focus points) (soft edges for blur points)
Using the Spot Repair tool
With Patch Tools

2. Eye Lashes
Adjust the brush to adjust the fine hardness of the black painting

Eight. Treatment of eyebrows

1. Draw Eyebrows
Point Layer-new-layer-mode soft light-Create clipping mask using the previous layer hook-mode tick
Point Burn Tool-tip exposure 50%-size 60 pixels-delivery hook-hardness 0

Related Technical steps for portrait post-processing basics