Rotten mud: [solution] ESXI5.0 dual Nic is installed in VMware Workstation, workstationesxi5.0

Rotten mud: [solution] ESXI5.0 dual Nic is installed in VMware Workstation, workstationesxi5.0

This article was sponsored by Xiuyi linfeng and first launched in the dark world.

As we need to conduct ESXI-related experiments, we will use VM Virtual ESXI on our own machine for the experiment. Because this experiment requires two NICs, we added two NICs when creating an ESXI virtual machine. As follows:

However, the problem occurs. After the ESX installation is complete, only one Nic is found. Because it was not present at the time, it cannot be displayed here. You can only view one network card at the nic of the esxi configuration management address.

Later, no related materials were found and related solutions were found. You cannot change the ESXI version from 5.0 to 5.1. Changing the ESXI virtual machine does not work either.

Later, there was no way to adjust the processor of the ESXI virtual machine. As follows:

The number of processors is changed from 1 to 2. The number of cores of each processor is changed to 2. In this way, you can see another network card that has been in violation for a long time when logging on to ESXI again.

However, in order to write this article yesterday, we restored this error and found it. No matter how you adjust the processor of the ESXI virtual machine, it cannot be restored.

Later, I thought about it carefully. We restarted the machine in the middle. I suspect that it is very likely that I have installed software that causes the problem of being unable to identify another Nic. The problem disappears after restart.

If this problem does not occur, this article will record it.

Vmware esxi50 implements the underlying architecture. How can we solve the problem of having only one ip address inside the Virtual Machine ip address?

This is definitely not possible. Here is a solution:
1. Set the esxi management address, for example, 192.168.0.x.
2. Set the network card addresses of 2008 and 2000 to 192.168.0.x.
3. Open another virtual machine, make it a virtual router, configure a dual-nic, configure one Nic to 10.30.0.25, And the other Nic to configure the private IP address 192.168.0.x.

4. Configure routes and policies on the vro to allow 2008 and 2000 access to the Intranet and 2008 and 2000 over the Intranet.
This should be acceptable, but I have never actually done so, so I can only provide one idea for your reference.
 
How can I install a 64-bit OS in esx when installing esx in VMware workstation?

Remember to add a parameter. If you forget the specific parameter, you can also choose to upgrade to workstation8, install esxi5.0, and then install the system in 5.0. This is no problem, however, if your CPU supports 64-bit Cpu, I will install it in my notebook, so it must be difficult. In addition, I checked the vt-x/ept in the CPU settings on the esxi5.0 virtual machine.