Route setting methods and application skills for ADSL in Beijing Harbor

1. Set the TCP/IP attribute of the NIC first:

IP Address: 192.168.1.2 because the default IP address of the cat is 192.168.1.1, as long as it is in the same network segment as it)

The subnet mask is 255.255.255.0.

Add 192.168.1.1 as the new Gateway

Set an available DNS!

2. Open the browser and enter http: // 192.168.1.1 in the address; username and password harbor) to enter the WEB configuration interface.

3. On the "Homepage", check whether the value of VPI/VCI is the same as that of VPI/VCI in the "wan interface" setting status.

If there are the same, write down the ATM interface corresponding to the corresponding VPI/VCI) That is aal5 -*. Because the corresponding ATM interface is selected in the quick settings described later, the Modem will automatically select the VPI/VCI value.

Select "quick Settings" on the homepage to go to the quick settings page.

Here is an example:

For example, in the "wan interface" Settings VPI/VCI corresponds to the aal5-4, the ATM interface Selection: 4

● Run mode selection: Enable

● Encapsulation Format Selection: PPPoE LLC

● Bridging: Disable

● Enable DHCP Selection: Disable

● Select Enable as the Default Router.

● Username: phone number

● Enter the password: Your Password

● Enable DNS Selection: Enable

After entering the relevant information, you do not need to change other parameters. You can retain the default value. Click "Submit" to save the settings.

If the value of VPI/VCI in the preceding parameter is different from that of any VPI/VCI in the "wan interface" setting status. The settings in quick settings are as follows:

For example:

● ATM interface Selection: 0

● Run mode selection: Enable

● Encapsulation Format Selection: PPPoE LLC

● Bridging: Disable

● Enable DHCP Selection: Disable

● Fill in VPI: 8 or 0. Here are the two numbers in Tianjin)

● VCI: 35

● Select Enable as the Default Router.

● Username: phone number

● Enter the password: Your Password

● Enable DNS Selection: Enable

After entering the relevant information, you do not need to change other parameters. You can retain the default value. Click "Submit" to save the settings.

4. Permanent storage

On the settings page, Save settings. Click "save" & "restart", and click "save"

Click it to save the settings. Click "restart" to restart the Modem.

(T113)