Router tplink882 static IP do not access the Internet how to do

routers tplink882 static IP can not be used to solve the Internet:

Broadband Line (household network cable or from the modem out of the network) needs to be connected to the router's WAN, the wired computer should be connected to the LAN port, the following figure:

If the line connection is correct, but the WAN port LEDs are not lit, check the WAN port wiring for bad contact, and try replacing the network cable that connects the WAN port.

Log on to the router management interface, in the running state >>wan port status, see Wan port Internet mode is static IP. If this is not normal, follow the Setup Wizard to set up your router's dynamic IP Internet access. The following figure:

Computer needs to be set up to automatically obtain IP address, if the computer is already automatically obtain IP address, if the parameters are not correct, please put the computer corresponding to the local connection or wireless connection disabled after the Enable.

Note: If the router DHCP server is turned off, you need to manually configure the IP address on your computer, please fill in the correct gateway (the router's management IP), the DNS server address (see the DNS address in the >>wan state of the Routing management Interface).

Connect the computer that was previously connected to the broadband connection to the router's LAN port (this must be via a wired connection) and log on to the router's admin interface.

Select network parameters >>mac address clone, click Clone MAC address. When the MAC address is the same as the MAC address of the current management PC, click Save and restart the router. As shown in the following illustration:

Observe whether the WAN port can successfully obtain the IP address after the router restarts.

Note: If you are using the Mini router, please record the MAC address of the computer connected to the Internet, and then fill in the MAC address above (without clicking the clone MAC address), save and restart.

The router's "Parental Control", "Internet Control" (part of the router is set up for the firewall) function can restrict intranet computer Internet access, please set this function according to the actual requirements, not necessary, do not enable the feature. Set the method as follows:

1. Turn off Parental controls

Login to the Router management interface, click on the Parental Controls Settings page, choose not to enable and save. As shown in the following illustration:

2, off the Internet control

In the security Settings >> Internet control, confirm that do not check to open the Internet control, save. As shown in the following illustration:

To do this, try opening the Web page test online.

Check your browser settings and check the following methods:

Disable dial-up connection: Open IE browser, click Tool >>internet option, select connection >> never dial connection.

Disable Network agent: Click Tool >>internet option, select Connection >> LAN settings, make sure three options are not checked, click OK, go back to the previous Internet Options dialog box, and click OK. As shown in the following illustration:

Set up, try to open the browser to the Internet.

Replace the browser (using Firefox/firefox, Google/chrome, or other browsers) to try again, if still not online, try to change the computer to do a comparative test.

Household network cable due to aging, poor quality or too long line, resulting in line attenuation is too large, resulting in a WAN port parameters, but not the Internet. Try to adjust the speed and duplex mode of the router's WAN port.

Setting Method: Login Router Management interface, click the network parameter >>wan port rate mode, select 10Mbps half-duplex or 10Mbps full-duplex mode in the mode setting, then click Save, as shown in the following image: