Routing can better manage network traffic

How can we better manage network traffic? How to Use the Tommato firmware? How can we improve the quality of Configuration Services? This article will give you a detailed introduction. I hope this article will help you.

Third-party routing software has been released for a while, but we do not have to recommend these products to users who want to add new features to the home network. Our favorite router firmware package is still Tomato, because it provides good compatibility for all brands and models of routers, and its user interface is friendly and powerful. Next I will show you how to upgrade the router firmware to the latest Tomato version, and then configure the Quality of Service (QoS) to manage network traffic.

Install Tomato firmware

First, make sure that your Tomato supports your vro. Linksys WRT54G series routers have the best effect, but some Buffalo and Asus routers are also good. You can check Tomato's FAQs to see if your route model and version number match. Download the latest firmware package. Use the gateway address (the default address is 192.168.1.1) to access your route management page and find the firmware update. Select the firmware. binfile that matches the route and start the upgrade process. Tomato automatically adjusts the route settings, so we do not need to reconfigure the Basic settings.

Configure Service Quality

Service quality allows us to manage different types of data packets because they are connected to the home network and service operators. Surfing the Internet, gaming, VoIP, and BitTorrent can both be prioritized, so we can run network services at the same time without imposing a burden on broadband. No group of settings applies to everyone, but we can provide you with some basic settings.

Service quality can classify network traffic, and then you can command all traffic to make the traffic at the bandwidth. First, you must determine your maximum uplink bandwidth. We can use Speedtest.net to determine the upload ceiling, and then control the number below the maximum bandwidth.

Next, you must configure the bandwidth range for different data packets in the upper and lower layers. By default, the highest level is 80%. This means that this level of data packets will occupy at least 80% of the bandwidth. On the other hand, the minimum range is 2% to 95%. This means that data packets below this level occupy a maximum of 95% of the bandwidth. High-level services are reserved for services that require stable connections, such as games and VoIP, while low-level services are reserved for surfing, downloading, and point-to-point networks similar to BitTorrent.

Under the category menu, we can set the level for the specified service. We can identify the service through the network protocol type, port or packet size of the service. You can even use the MAC address and local IP address to restrict the use of a user in the home network for a specified priority category. We recommend that you use the Tomato graphic function to show the impact of your configuration on the current traffic.