Selection of Netcom broadband wireless router settings

The general user may not be particularly familiar with the configuration of the Netcom broadband wireless router. So I have studied the specific steps of the wireless route settings and will share them with you here, hoping to help you. First I would like to talk about my home network computer: two desktop + 1 laptop, one of the desktop installed wired network card, the rest of the installation of TP-LINK 54M wireless network card, there is a supporting TP-LINK54M router. Network Access refers to WAN port connected to China Netcom, LAN port connected to a desktop, and other connected via wireless network card

Start a computer and use IE to open the management interface of the Netcom broadband wireless router settings, change the default 192.168.1.100 and 192.168.1.199 to 192.168.0.100 and 192.168.0.199 in "DHCP server"> "address pool start address" and "address pool end address" to "restart the router, then change the default IP address of the vro to 192.168.0.1 in "Network Parameters". Do not reverse the order of the two steps. If it is reversed, the IP address cannot be allocated, at this time, you need to manually modify the TCP/IP protocol for computer network connection to change the IP address to 192.168.0.x, And the subnet mask 255.255.255.0 is automatically filled in), the gateway is 192.168.0.1) restart the router again. These steps prevent access to the website, because the ip address of the website is 192.168.1.40, which is in the same CIDR block as the default Intranet IP address set by the China Netcom broadband wireless router, this will cause access failure.

Open the Netcom broadband wireless router settings management interface and write the address you are locked in "Network Parameters"-"MAC address clone, it is the MAC address query method of the network card that you can log on to. Start -- run -- Enter CMD -- and then enter ipconfig/all in the command line, you can find the MAC address, not Google), and then the most critical step, in "forwarding rules"> "DMZ host", enter the address pool start address of the DHCP service. In this case, enter 192.168.0.100 and click "enable" to save the address. In this case, restart the vro again.

Then install the dr.com login software on the three computers, and change the mac address of the three computers to the locked one under the control panel -- "system" -- Device Manager -- Network adapter -- Network address, the following steps are also critical. log on to the computer that was first started up, and log on successfully. Now all three computers can access the Internet! What's more, you can choose which server you want to use. I used to use a computer as a host, then, the two NICs are connected to the China Netcom line and connected to the WAN port set by the China Netcom broadband wireless router. Then, the other two are connected to the vro through wireless connection to achieve shared Internet access, however, there are two problems: one is that the host must be opened, so that the computer in the study room with a notebook online on the bed has to be opened, not only troublesome, but also does not affect the computer life for years; second, file sharing is impossible. MP3 and movies on the host cannot be viewed on other computers. Now, in this way, we can completely solve these two problems. Through the Broadcast Function of iTunes, we can listen to songs on other computers, and it will be OK if we want to enable it.

In fact, the principle is very simple. Through the DHCP service set by the Netcom broadband wireless router, the first address of the address pool is always allocated to the first opened computer. Here it is 192.168.0.100 ), then, the computer with this address is completely exposed to the WAN through the DMZ host, and the computer can be used with DR. COM login software login. I hope to help some users with the same problems, because I have not found a solution on google for a long time. I also hope you can give me some advice!