Set the program to start and configure the network under Fedoral

1. set the program to start with the System: System-& gt; preference-& gt; startupprograms-& gt; add1. open the setting window. 2. click Add, add 3. enter the Name of the program to be added in the Name box, and enter the target of the program to be added in the Command box. if you do not know where to add it ,...

 

1. set the program to start with the System: System-> preference-> startup programs-> add

1. Open the Settings window.

2. click Add to Add

3. enter the Name of the program to be added in the Name box, and enter the target of the program to be added in the Command box. if you do not know where it is, right-click the program icon and select Properties, take Teamviewer as an example. for example, the content in the Command is the content to be entered in step 1.

4. after adding the device, close the window and start automatically with the system at the next boot.

II. how to set network System> preference> network Connections

1. Open the Settings window.

2. select the NIC to be configured and double-click it, as shown in:

3Set the Wired option and IPv4 Settings option in this window, enter your MAC Address in the Cloned MAC Address, set the IPv4Settiongs option to "Manual,

In Address, click the Add button and enter your own IP Address, subnet mask, Gateway, and preferred DNS respectively. then click Apply! After configuration, refresh the network.

 

From the column of SHMILYRINGPULL