In this paper, the Repeater mode Repeater radio signal setting method of TL-WR700N is introduced.
The application topology of TL-WR700N working in relay mode is as follows:
Application topology of TL-WR700N relay mode
1
Confirm the master router parameters
Log on to the management interface of the wireless router (that is, the primary router) to be connected, and confirm the SSID, wireless password, and other parameters. The following parameters are used as an example:
SSID:Zhangsan;
Wireless password: 1a2b3c4d.
2
,
Set wireless network card
Before setting a vro, you must set the wireless network card of the operating computer to automatically obtain the IP address. If you do not know how to set it, refer:
Pull the pattern switch of the TL-WR700N
AP
Mode, As shown in the following figure:
The default SSID of the vro is:
TP-LINK_XXXXXX(The last six digits of the MAC address), select the operating system of the computer on the following icon, and set the wireless signal for the computer to connect to the Mini router according to the instructions in the document.
1
, Enter the management address
Open the browser on the computer desk, clear the address bar, and enter
Tplogin.cn, And the login box will pop up after you press Enter.
2
, Logon Management Interface
If this is the first login, you need to set the management password of the router. In
Set password
In
Confirm password
And click
OK. If you have set a password, enter the password to go to the management page.
If you cannot log on to the management page after entering the management address, click to reference:
1
Start setting Wizard
Go to the vro management page and click
Setup Wizard, Click
Next Step.
2
, Select work mode
Select
Repeater: Relay mode, ClickNext Step.
3
, Scanning signal
On the wireless settings page, click
Scan.
4
Select the main router signal
Find the SSID of the primary router on the scan page, and click
Connection.
Note:: If the signal of the primary router is not scanned, make sure that the wireless feature is enabled on the primary router and try to reduce the distance between the primary router and the Mini router.
5
Enter the wireless password
In
KeyEnter the wireless password of the master router and click
Next Step.
6
, Restart the router
Click
Restart, Click in the pop-up dialog box
OK.
The computer scans the wireless signal and determines that the signal strength has been enhanced, and connects the wireless signal (zhangsan) after the relay ). Log on to the vro management page and click
Running status, Observe
Wireless status
>
Relay status, Display
Successful
The Repeater mode is successfully set.
