Simple steps to enable the Linuxtelnet service

Simple steps to enable the Linuxtelnet service when using the Linux system, many settings are different from Windows settings. Here we will mainly explain how to enable the Linuxtelnet service. In Linux, telnet is not enabled by default. how can I enable it? First, change the simple steps to enable the Linux telnet service when using the Linux system, many settings are different from Windows settings. Here we will mainly explain how to enable the Linux telnet service. In Linux, telnet is not enabled by default. how can I enable it? First change/etc/xinetd. d/telnet file, some may not have this file, such as krb5-telnet, then change this file, if it is a telnet with the edge of the file; it may be because the telent service is not installed, you need to take the disk and install it again, or you do not have it after installation. create a new file with the following content: 1. # default: off 2. # description: The authenticated telnet server accepts normal telnet sessions, \ 3. # but can also use Kerberos 5 authentication. 4. service telnet 5. {6. flags = REUSE 7. socket_type = stream 8. wait = no 9. user = root 10. server =/usr/kerberos/sbin/telnetd 11. log_on_failure + = USERID 12. disable = yes 13 .} change "yes" of disable = yes to "no", and restart the Linux telnet service input: service xinetd restart Stopping xinetd: [OK] Starting xinetd: [OK] The restart is successful. at this time, you can use the Linux telnet service to connect to the host. However, by default, the root user is not allowed to remotely log on via telnet in linux. either of the following methods can be used to solve this problem: 1, log on with a non-root user, and then switch to the root user. 2, set/etc/pam. the second line of the d/login file is commented out: # auth required pam_securetty.so; but I did not pass the test here.