SolidWorks how to draw a hinge hole bolt two-dimensional engineering drawing?

SolidWorks How to draw a hinge hole bolt two-dimensional engineering drawing?

1, click on the blank page "new" frame to the right of the drop-down arrow, select "From parts/assembly drawings to make engineering drawings"

2, select "A4" Engineering drawings, click "OK", into the engineering drawing editor

3, you can see the right side "drag the view to the engineering drawing drawings", which "on", "after" and "isometric" three views to the drawing, found that the relative drawings, the view accounted for is too small, not beautiful

4, click on the drawing "rear view" figure, in the left parameter setting box, find "ratio"/"Use custom ratio"

5, choose "User-defined", set "4:1" ratio, the view becomes larger, the overall beauty of the drawing is much more

6, select "Intelligent Size", the figure of some important dimensions marked out, finished saving the drawing.