Solution to computer disk hardware problems that Windows cannot start

Computer disk hardware problems, Windows cannot start the solution I have a computer to re-install the operating system, after the installation of the system, start the computer, there is no normal WINDOWS boot interface, however, "Windows cannot be started due to computer disk hardware problems and the selected boot disk cannot be read. Check the boot path and disk hardware. For more information, see disk configuration .", The computer cannot be started. After checking, make sure the operating system to be installed is correct. Then, I searched a lot of information online and finally sorted it out. I wish you success !!! Method 1: first check the boot. ini system configuration file of drive C. Open it and you will see [boot loader] timeout = 3 www.2cto.com default = kdind? Djidmn? Jckjf? /WINDOWS [operating systems] kdind? Djidmn? Jckjf? /WINDOWS = "Microsoft Windows XP Home Edition"/fastdetect/NoExecute = OptIn if you have modified this boot file before, you will find that this configuration file is incorrect, it causes the computer to fail to boot into the normal operating system interface and cannot start the computer. Here is the problem. Let's modify this file. You can refer to the boot. ini configuration file of another computer to modify it. After modification, the correct boot. ini configuration file: www.2cto.com [boot loader] timeout = 3 default = multi (0) disk (0) rdisk (0) partition (1) /WINDOWS [operating systems] multi (0) disk (0) rdisk (0) partition (1) /WINDOWS = "Microsoft Windows XP Home Edition"/fastdetect/NoExecute = OptIn and then save boot. INI file, and then restart the computer, you can use the Bootcfg utility in the fault recovery console to correct the Boot. ini file: 1. start your computer with the Windows XP CD-ROM. Www.2cto.com 2. When you receive a message to use the Recovery Console to repair Windows by pressing the R key, press the R key. 3. Select the required Windows installation, and enter the administrator password when prompted. 4. Type bootcfg/rebuild and press ENTER. 5. After Windows is installed, the following description is displayed: "Add installation to boot list? (Yes/No/All) "[Type Y to respond to this message.] Enter Load Identifier: [This is the name of the operating system. Type Windows XP Professional or Windows XP Home Edition.] Enter OS Load options: [leave this field blank and press ENTER]. After performing the preceding steps, restart the computer and select the first item in the boot menu. This should enable Windows XP. After successfully loading Windows XP, you can modify Boot. ini to delete incorrect items. Method 3 1. Use the Windows XP CD-ROM to start the computer. Press any key to boot from CD. 2. After loading the installation file, press the R key to use the fault recovery console for repair. 3. In the fault recovery console, select the installation to log on to (usually numbered 1) and press ENTER. 4. log on to the administrator account by entering the password of the Administrator account, and press ENTER. 5. at the command prompt on the Recovery Console, type the following command and press ENTER: for a single processor system: expand cd-rom: \ i386 \ ntoskrnl. ex _ drive: \ Windows \ system32 for multi-processor systems: expand cd-rom: \ i386 \ ntkrnlmp. ex _ drive: \ Windows \ system32 \ ntoskrnl.exe Cd-rom is the drive letter of the CD-ROM drive and the drive letter of the hard disk where Windows is installed. 6. If you receive a prompt to overwrite this file, Press Y. Www.2cto.com 7. Type exit and press ENTER at the command prompt. Method 4 Use the fault recovery console to start the computer and then run the CHKDSK/r command. Note: do not include the/p switch in the Chkdsk command line, because the/r switch will enable the Chkdsk utility to locate Bad Sectors and restore readable information. This command implies the/p switch. After the system is built with the ghost disk, the system returns to normal.