Solution to font installation failure in Win10 System

Solution to font installation failure in Win10 System

When installing the system, in addition to the built-in font software, we also install some of our favorite font software. Some Win10 users reported that some new fonts downloaded from the internet failed to be installed. At first, it was suspected that there was a problem with the downloaded font. However, if different fonts were downloaded from multiple websites, the installation failed. What if the font cannot be installed in Win10? The following describes how to solve the font installation failure of win10.


　　
　　What if the font cannot be installed in Win10? How to solve font installation failure in win10.

As a result, the new font cannot be installed on Win10. It turns out that Windows Firewall is disabled. The reason is that the Windows Firewall Service was disabled when the security guard was used to optimize the system startup Item.
　　
In fact, this small Editor is also a bit embarrassing. When Windows Firewall Service was previously disabled, 360 security guard only prompted to be related to network printer sharing. I did not expect the font to be affected, this 360 security guard prompt is also misleading, hoping to attract your attention.

Solution to font installation failure in Win10

The solution is simple. You only need to enable the Windows Firewall service. If security guard is installed on your computer, start the Windows Firewall Service in the startup item, and then restart your computer, then you can install the new font.

You may need to uninstall or not install the security guard on your computer. The following describes how to enable the Windows Firewall Service.

1. Open the run operation box (you can directly use the Win + R combination shortcut key to open it), type the command: services. msc, and click OK below to open the service ,.

2. Pull down the right side of the service panel, find the Windows Firewall Service, and double-click to open it ,.


　　
3. After setting the Windows Firewall service attribute, change the Startup Type to "automatic", and click "start" at the bottom to enable the Windows Firewall Service, click "OK" below to save ,.


　　
Follow these steps to install the Win10 font after the Windows Firewall Service is successfully enabled. If you cannot install a new font in Win10, follow these steps.