Solution to Linux system Sureha 2 cluster disk resource/Mirrored disk resource fsck setting causes the startup time to be too long

Linux system Sureha 2 cluster disk resources/mirrored disk resources The default settings partition mount to a certain number of times after the fsck test, it may take a long time, the default timeout is 1800 seconds, if the amount of data is large, may even cause the resource to start failure due to timeout.

Solution:

You can turn off the fsck settings directly in the HA settings.

Switch to set mode, select the corresponding resource in failover, right-click to select Properties, and click Adjust on the Details tab, as shown below:

On the Fsck tab, set Mount fsck before execution to no execution, as shown in the following figure:

After this setting, you can skip some checks. This method also solves the problem of the disk resource/Mirrored disk resource fsck setting causing the startup time to be too long.