Solution to "Data error (cyclic redundancy check)" Problem when installing drivers

In the Drive life or manual installation drive, sometimes there will be "data error (cyclic redundancy check)" prompts, this situation is mostly due to hard drive bad road caused by errors, the following small series to tell you how to solve.

Open Drive Life--software--system Tools, find HD Tune HDD Detection tool, download installation, select Error scanning, start on the hard disk scan, the following figure, if the scanning process appears red small square, it is considered hard to have bad road

Workaround (Make sure your computer is in compliance with the above)

Logical corruption (software and system reasons): Right-click Computer--management--Disk Management--Select the right key property of the volume (such as C-disk)--tools--Start checking, all checked, so that each letter will be repaired:

Physical damage (hard drive damage): Replace the hard drive or find out after the sale

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join