Solution to "Check Network Configuration Requirements not executed" during Oracle 11g Installation

Checking Network Configuration Requirements...

Check complete. The overall result of this check is: not executed

I checked it on the Internet and many of my friends encountered this problem, but it was easy to solve it.

You only need to install Microsoft LoopBack Adapter [Microsoft LoopBack Adapter] in Windows XP.

Microsoft loop adapter is a tool that can be used for testing in a virtual network environment, in which the network cannot be accessed. In addition, if there is a conflict with the network adapter or Network Adapter Driver, you must use the loop adapter. You can bind the network client, protocol, and other network configuration items to the loopback adapter, and the Network Adapter driver or network adapter can be installed later while the network configuration information is still retained.

To manually Install the Microsoft loop adapter in Windows XP, follow these steps:

Click Start, and then click Control Panel ".

If you are in the classic view, click switch to category view under control panel in the left pane ".

Double-click "printer and other hardware" and then click "Next ".

In the left pane, under "see", click "add Hardware", and then click "Next ".

Click "yes, I have connected to this hardware", and then click "Next ".

At the bottom of the list, click Add new hardware device, and then click Next ".

Click "install hardware I manually selected from the list", and then click "Next ".

Click network adapter, and then click Next ".

In the manufacturer box, click Microsoft ".

In the network Adapter box, click Microsoft LoopBack Adapter, and then click Next ".

Click Finish ".

After the adapter is successfully installed, You can manually configure its options, just like any other adapter.

At this time, we will see an additional "local connection 2" in the network connection"

Set the IP address as needed, 10.10.10.10, subnet mask 255.255.0, and leave the gateway blank.

Modify the hosts file in the C: \ WINDOWS \ system32 \ drivers \ etc folder and add

10.10.10.10 yourcomputer, where "yourcomputer" is the host name.

After the above settings, the system will pass the recheck.

If you encounter the same problem, I hope this will help you ~