Some common slackware configurations

Some common slackware configurations took some time to install slackware14x86_64 on the notebook. it feels okay. Linux and Windows are not installed this time. slackware is run separately, and xp is run in the virtual machine, mainly for the use of online banking and the compatibility of office. Some common configurations of w... slackware took some time to install slackware14 x86_64 on the notebook. it feels okay. Linux and Windows are not installed this time. slackware is run separately, and xp is run in the virtual machine, mainly for the use of online banking and the compatibility of office. The installation of www.2cto.com slackware is more complex than the general release version, but it can still be done by people familiar with linux. During installation, the boot USB flash drive made by ultraiso is used. if you modify the bios to enable the USB flash drive, the installation will be started. The only thing stuck during installation is to select the Directory of the installation source, be sure to select the slackware Directory. I mount the USB flash drive to/U, so select the/U/slackware directory. Other posts that follow the instructions or are illustrated on the Internet. Www.2cto.com? Because LILO has never been used, and grub configuration is familiar, grub is used. Grub2's on the U drive was not successful, and grub2's on the Internet was also used. The last call was grub-2.00.tar.gz. after the installation was successful, it was not found to be grub2 at startup. In this way, it will be used, at least the whole system is running. The first thing to do when the system runs is to connect to the network. with the network, you can ask google to find a solution to various problems in the future. Slackware has the following website: http://slackbuilds.org/ . General software installation packages and libraries can be downloaded from above. NetworkManager is used for network management. after the network is installed, you will basically know how to use it. The second thing is the input method. slackware uses SCIM. people who are used to IBUS in ubuntu are not very familiar with it at the beginning. At the beginning, I was about to replace SCIM with IBUS. if it was not successful, I installed google Pinyin input method under SCIM. I am getting used to these words. The third thing is the installation of vmware. if the vmware9.0 is downloaded, the installation on the GUI always prompts failure. The command line method is used for installation, and the -- console -- ignore-errors parameter is added. The main purpose of playing linux is to build an embedded linux development environment. It mainly involves several configurations: 1. Cross compiler. Decompress the compiler to a proper place and change the PATH environment variable 2. The mini-com slackware comes with the following configurations. My serial port is usb to serial port. The linux driver is very powerful and can be used directly. The nfs configuration root file system uses nfs root, so you need to configure nfs. Modify the/etc/exports file and add/nfsroot/rootfs 192. 168. *. * (rw, sync) then chmod 755/etc/exports; chmod 755/etc/rc. d/rc. nfsd; chmod 755/etc/nfsmount. in this way, the nfs service will be started when the instance is started. You can also manually start/etc/rc. d/rc. nfsd restart 4. Tftp configuration/etc/inetd. conf remove the comment of the line configured by tftp: tftp dgram udp wait root/usr/sbin/in. tftpd in. the default directory of tftpd-s/tftpboot-r blksize is/tftpboot, which encountered many problems throughout the slackware installation and configuration process. some problems cannot be recalled now, if a new problem occurs later, add a solution here.