Summary of port image configuration of Huawei switches (1)

Image PortSimply putVswitchOne copy of the traffic of multiple) Port source ports is completely copied and sent from another port destination port, so that the network administrator can analyze the traffic of the source port from the target port to find out the cause of the network problem.

After the port image of the vswitch is configured, You can conveniently monitor and manage your network by using the netjob internet behavior management software. You can use netjob to monitor and manage the company's internet records and QQ chat content, MSN Chat content, email sending and receiving records, etc. Let's take a look at it.Huawei SwitchesHow to proceedPort image ConfigurationOf:

Configure environment parameters: the IP addresses of PC1 and PC2 are 10.10.1.1/24, and 10.10.1.2/24, respectively.

Networking requirements: configure a port image on SwitchA to monitor the packets sent and received by pc1.

Huawei switch: S2000EI, S2000C series port image configuration process

Using ing-port to defineImage Port, Monitor-port is used to define the monitoring port.

SwitchA configurations]

1. Configure port E0/2 as the monitoring port

[SwitchA] monitor-portEthernet0/2no-filt

2. Configure port E0/1 as the mirror Port

[SwitchA] mirroring-portEthernet0/1 both

Additional description]

Multiple-to-one port mirroring is supported, but the mirroring port must belong to the same chip as the monitoring port (one chip per eight ports ).

When configuring the Image Port, you can use parameters to define the direction of the monitored packets. For example, the both parameter indicates that packets are received and sent by the monitoring port at the same time. The inbound parameter indicates that only packets received by the monitoring port are monitored. The outbound parameter indicates that only packets sent by the monitoring port are monitored.

When configuring a monitoring port, you can use parameters to define the monitoring port type. For example, the parameter no-filt indicates that all packets are monitored; the parameter filt-da indicates that only packets of the specified destination mac address are monitored; the parameter filt-sa, monitoring only the packets of the specified source mac address.

Specific models of this series switch include: S2008-EI, S2016-EI and S2403H-EI, S2008C, S2016C and S2024C.