Configure point-to-point connection instructions for that ZigBee (Wbee)
The configuration process is divided into two-part zigbee-a (Wbee) configuration zigbee-b (Wbee) configuration
Reference Address: http://www.winertech.com/xzzx1.asp
One, zigbee-a configuration
1, connect the ZIGBEE-A debug serial port to the computer serial port, make sure the connection method is correct:
2. Open the Zigbee-a Configuration Utility Config Tool software to open the appropriate connection string number, other options are configured by default parameters:
According to the ordinal order: 1, select the serial number that is connected with the device->2,3,4,5, the default configuration->6, after opening the serial port, according to the upper right prompt, re-power the device or has been powered on, please re-power.
3,zigbee-a after entering the configuration state, modify the working mode to the coordinator, set the local address and destination address to AAAA and bbbb respectively, and the other parameters are unchanged.
4, confirm the network parameter value setting, 1, Network ID 2, basic frequency 3, data rate, general default configuration. Must be consistent with the Zigbee-b network parameter settings. Such as:
5, save the parameter configuration, restart the device to enter the communication status.
Two, zigbee-b configuration
Configuration steps 1,2,4,5 Ibid.,
Configuration step 3:zigbee-a After entering the configuration state, modify the operating mode for the router, set the local address and destination address to bbbb and AAAA, respectively, and the other parameters are the same.
Third, when the status of two devices in the blue flashing state, with the serial tools to open the Zigbee-a and Zigbee-b debugging serial port, test data on whether the normal communication.
Teach you how to configure ZigBee module for Point-to-point communication instructions