Teach you how to set up a wireless route

At present, the application of WLAN has become an important means of high speed wireless data access in indoor community, especially in hot area. Many readers still have a smattering of wireless routing settings. This time we specially take a wireless router as an example, detailed introduction how to set up the router. Wireless routers in the market a wide variety of, but million change in which, as long as the reader extrapolate, no line by the setting nature can be easily.

For broadband wireless access network, there are currently three kinds of standard protocols worldwide, namely ATM Forum standard, European ETSI Standard and IEEE standard. IEEE Standard protocol is the most widely used WLAN standards in the World, the 1997 IEEE 802.11 standard was first developed, marking the creation of wireless LAN.

Although the IEEE 802.11 standard has been in place for many years, it may be that the cost of equipment and the popularity of lenient issues have been delayed in the domestic market and user acceptance. By the end of the 03 and early 04, the IEEE 802.11B standard wireless router was starting to get a bit of attention from some users, especially those who owned notebooks. In a short span of 04 years, the domestic users of lenient greatly increased, and the IEEE 802.11g standard wireless network equipment cost unit price has also been a sharp decline, so that the IEEE 802.11g standards have been further popularized, it is clear that the IEEE The 802.11g standard is appropriate for homes and small offices, and is faster than the IEEE 802.11b standard, and of course the IEEE 802.11b standard is perfectly manageable for simple Internet access, while IEEE 802.11G can satisfy users to transfer large files, and the cost of IEEE 802.11g equipment is now fully acceptable to users.

Wireless equipment, we have selected a higher market penetration tp-link Wireless Router wr541g 54M Wireless set, the market price of the product is 399 yuan (the price is always price), is an entry-level product.

No wiring by configuration instance:

Before configuring the wireless router, we first need to connect the relevant lines. First plug the internet cable into the WAN port of the wireless router, and then we need a computer to configure the router through the LAN port that connects the router to the network. The first step is to ensure that the TCP/IP protocol is installed on the local computer operating system, which can be ignored for users above the Windows 2000 level. Because the router defaults to 192.168.1.1 and the subnet mask is 255.255.255.0, we must manually set the local connection address to the same network segment to properly configure the router, that is, to set the local connection address to 192.168.1.xxx (xxx=2~254). The subnet mask is 255.255.255.0. After the setup is complete, open IE enter 192.168.1.1 The default address without a line will pop up the above window, requiring the user to enter the administrator's username and password. User name and password can be learned from the product specification, generally for admin.