(Temporarily) solve the problem that infopath always displays "installing"

I was asked a question during work hours: The infopath status is always "installing" and cannot be set to "ready. Since there is no moss environment, I can only go home at night and watch it again. I tried to release an infopath, and it also showed that the status was always "being installed", but not "ready ", maybe my question is different from the question I was asked, but I should keep it down :)
Problem REPLAY:
Click "manage form template" in "infopath Forms Services ".

Click Upload form template ".

Select the infopath form and Click Upload ".

After the upload is complete, the status shows "installing ".

If activated to the website set (ready to be activated to the website set), the following error is shown in the image.

I checked the error in "note status,

Maybe there is a problem with the record operation, and then you start to find the error... However, "the form template cannot be activated because it is still being uploaded to the site. Please wait until the form template status changes to" ready "and try again ". I think a job may have been created, but it cannot be run or it has not been started yet. Therefore, force the job to execute it immediately. If you want to try it, run the following command:

After the prompt is executed, return to the template list. Hey, the status turns to "ready"

It seems that it is good. Continue to try it, activate it to the website set, complete it correctly, and go to the website content type library. Set the form content type and create a new form:
 
Display:

Completely normal...
I have not figured out the specific cause of this problem. I think it may be because the two machines are not synchronized for some reason, so the form is always in the "installing" status, or a problem occurs in the SharePoint job service. The specific reason is not found yet. Now, you can use this command to execute every time you upload the infopath form. This is depressing.