Tenda Tengda Wireless Router How to set up

First step:

Connect a good line, an outside line inserts a WAN port and then uses a network cable to plug in one of the remaining 4 ports and connect to the computer (the IP of the NIC is set to get the method automatically or the IP set to 192.168.0.X (2-254) is not specifically understood). Then open IE, enter 192.168.0.1 in the address bar as shown

Step two: The following interface appears, the default username and password are admin

Step three: Enter the Setup interface, click "Quick Settings", and then the selected "ADSL virtual dial-up (PPPoE)" will appear as follows, click Next

Fourth Step: Setup Wizard-ADSL, this requires you to enter the Internet username and password, after filling out the next step to select

Fifth step: Setup complete, click to save Exit settings

Note that if the setup completes the need to restart the route, go to the setup page of the "System tool" to click the "Restart the router" option, do not poke the router's butt! Otherwise, the work in front is wasted!

When set up, you can see whether the router is connected to the network in run state.