The tengda router obtains the WAN address. Today, I want to introduce two problems that occur when the WAN port of the tengda router obtains the Internet IP address. Let's take a look! 1. The tengda router cannot obtain the IP address of the Internet.
(1) check whether the tengda router and the broadband access network cable have been connected, whether the WAN port indicator of the tengda router has been on, and then check whether the tengda router has been correctly configured and saved and restarted. (2) Sometimes broadband providers may limit the number of computers used and bind the MAC address of the computer Nic. In this case, the MAC clone function of the Tenda router Nic is required, clone the MAC address bound to the computer Nic to the tengda router. 1. tengda 6606: Click Clone MAC in other options in management and settings to restart; 2. tengda 6606 +: Select Connect Setup in Connection Setup and Cable, after entering, click the Clone MAC button; www.2cto.com 3. tengda 6609: In the initial settings of Basic settings, select a dynamic IP address and click the Clone MAC button; 4. tengda 6609A2: in management, set the MAC address of the replication Nic to ENABLE and click Application to restart. 2. The tengda router has obtained an Internet IP address, but still cannot access the Internet.
(1) Confirm that the Default Route has been set to Enable in the tengda router quick setting. (2) Check the IP address of the computer. If you manually set the IP address, check whether the gateway is consistent with the tengda router, whether the DNS is the DNS of your broadband, and if you use the automatically obtained IP address, release the IP address or restart the computer. The above are two common problems that tengda routers often encounter when obtaining Wan addresses. netizens who are troubled by the same problem can try to solve the problem. This article is from