The first step: connect the Good Line
Step Two: Enter O3 's management side
Third Step : Select the corresponding work mode
① sender O3: client - side mode
② receiving end O3: AP mode
Fourth Step : Confirm O3 whether the success of the secondary
Attached: Elevator monitoring full Wireless Application Mode
The line connection is shown in the following illustration:
Using a pair of O3 to carry out elevator monitoring application
One as the sender, the operating mode is set to AP mode, installed in the elevator box above, through the network cable to connect the Internet camera and advertising screen and other network equipment;
As a receiver, the operating mode is set to the client mode, installed in the elevator room, through the network cable to connect the switch, NVR and other equipment.
Note: The O3 antenna is a directional antenna and it is recommended that the O3 position of the transmitter and receiver be relative.
First, set the IP address of the network connection on the computer to "
use the following IP address "
, The value is " 192.168.2.X" (X is 3~253), Subnet mask is 255.255.255.0
In the Computer browser address bar, enter the AP default login Address
192.168.2.1
, and press ENTER, enter the default account on the jump page
:admin and
Password:admin, click
Login .
① transmitter O3:ap mode, connecting switches, NVR and other devices
Click "
Quick Settings " and select "
ap Mode "
Fill in the local wireless network name and wireless password in the box below
After confirming that the information is correct, click "
Save "
② receiver O3: Client mode, connect camera and advertising screen and other network devices
Log in the same way as the O3 on the receiving end
Select
Client Mode in the
Quick setup option
Open the Scan button and select the wireless signal sent by the
O3
Keep the channel, Safe mode, encryption mode, wireless password consistent with
the O3 Wireless signal on the transmitter in the bottom box option
Set Local IP information to ensure that it is inconsistent with the
O3 IP address of the sender, but in the same network segment, DNS can be set in the following box
After confirming that the information is correct, click "
Save "
Note: When there are multiple O3 , it is recommended that you first modify the default IP address to the same network segment different IP LAN port address, in case multiple O3 login addresses are 192.168.2.1.
1. After the success of the setup needs in the
client mode AP interface to see if the bridge is successful, enter the home click
System State -Wireless status .
2. To see if relay success, you can also see O3
bribge lamp, if the
BRIBGE lamp illuminated steady, then prove bridge success, in the client mode O3 side connected to the computer, ping to the end of the camera address, if you can ping through , the nvr can be searched to the remote camera.
3. View Client mode O3
signal intensity of signals and bridge-end equipment
Attached: Elevator monitoring full Wireless Application Mode
Set the working mode corresponding to the O3 as shown in the following figure
Note: The O3 antenna is a directional antenna and it is recommended that the O3 position of the transmitter and receiver be relative.
